The Framers Forum

Yes I am. To be clear I've been framing for 15 years so I am experienced. I only had the futura for a few weeks, had ulimat before and never had this problem.

Yes I'm on total adjustment, spring totally compressed and still get a large overcut on start of cut

Tried both tech 12 and 15. Think thickness is 1.2mm, sorry not sure what you mean by coil bound? Can you elaborate

Yes, done that.

No overcuts just on start of cut. Like I say dialled out maximum, still overcuts, yes using slip mount, brand new blades.

Hiya I have a keencut futura and struggling to remove overcuts on start of cut. Even on maximum dial out adjustment it still overcuts. Any ideas.

Might be a well trodden issue but have huge amounts of 2mm float glass of various sizes that I have accumulated that unlikely ever to use (in small volumes perhaps).

Other than dispose of any ideas.

Use adhesive foam board. Done a number works fine every time, needs care and attention when doing but cost effective way of doing.

I have two Underpinners for sales. Being advertised via ebay.

One is a Cassese CS830 air operated the other is a foot operated unit.

Ebay item ID's are 331099940744 and 331099943264

Mike