Trucut Mount Cutter - DXF - ODF file converter needed
Posted: Tue 23 May, 2017 9:50 am
I have a pretty old Trucut mount cutting machine running on Windows 95.
The software converts DXF files to ODF files so that the machine can make the cut.
I have had DXF files made out of shapes I provide, but when I try to convert these DXF files to ODF, I get a "General protection fault" when trying to load the ODF file.
Is there anyone on the forum who can provide the ODF file from a jpg/bmp/png file?
Alternatively, does anyone have a solution to the fault I'm getting?
The software converts DXF files to ODF files so that the machine can make the cut.
I have had DXF files made out of shapes I provide, but when I try to convert these DXF files to ODF, I get a "General protection fault" when trying to load the ODF file.
Is there anyone on the forum who can provide the ODF file from a jpg/bmp/png file?
Alternatively, does anyone have a solution to the fault I'm getting?