Page 1 of 1

Celtic Knot 1

Posted: Sun 22 Feb, 2009 2:11 pm
by Merlin
Test upload of Celtic knot
celticknot1.jpg
Celticknot1.plt

This Celtic Knot design is uploaded in .PLT format to allow you to import into your own CAD package and manipulate as you see fit.

The design size is 99mm wide, yet will go down to 40mm and still cut very well.

We have used this on many occasions as corner decoration for Wedding seating plans.

Re: Celtic Knot 1

Posted: Mon 06 Apr, 2009 6:35 pm
by James Miller
That's a very good design, John. Did you create it from scratch, or scan and import it to the program?

What would happen if you moved the closed ends of the lines closer together and overlapped some of them? I may try that.

Cheers,
Jim Miller, MCPF, GCF
ARTFRAME, Inc.
Hunters Run Center
1698 Hill Road N.
Pickerington, Ohio 43147
USA
ARTFRAME@att.net

Re: Celtic Knot 1

Posted: Mon 06 Apr, 2009 6:38 pm
by Merlin
I imported a photo (from wife's cross stitch library) into corel

the freehand over the top, smoothing out the nodes as I went. Saved at a PLT

Looks really nice when done small(ish)

Re: Celtic Knot 1

Posted: Mon 06 Apr, 2009 6:54 pm
by James Miller
John:

I took the liberty of tightening up the line intersections. When debossing or cutting with the white 90-degree head, I believe this may work better. Your thoughts?
Design-Celtic Knot 1.plt
Design-Celtic Knot 1.cdr