We have a job in for 32 frames that we need to get done over the weekend. I am looking for an efficient way of stringing them well but quickly rather tying lots of knots. Not overly worried about a little extra cost. I was thinking wire and crimping would be the quickest and best? Does any one use this method or have any other suggestions?
Many thanks
Mike
Stringing
-
- Posts: 66
- Joined: Mon 30 Sep, 2019 2:59 pm
- Location: South Wales
- Organisation: New business
- Interests: Work and work
Re: Stringing
I always use a double strand of SuperSoftStrand. One end is simply looped thought d-ring, fed back through
and pulled tight. Then loosely twisted and knotted at the other end. That way you only have to tie one knot.
and pulled tight. Then loosely twisted and knotted at the other end. That way you only have to tie one knot.
Watch Out. There's A Humphrey About
-
- Posts: 66
- Joined: Mon 30 Sep, 2019 2:59 pm
- Location: South Wales
- Organisation: New business
- Interests: Work and work
Re: Stringing
Thanks for that. I think i'll go that way. I can sit at home and loop them all first.
Mike
Mike
Re: Stringing
Before someone points out that I'm using twice as much wire as I need to, I use a lighter gauge wire than the job calls
for, i.e. If it needs no.4 wire I use two strands of no.2.
for, i.e. If it needs no.4 wire I use two strands of no.2.
Watch Out. There's A Humphrey About