Hello!

Say hello, and tell us a little about yourself.
Post Reply
Mafell
Posts: 2
Joined: Sat 26 Jan, 2013 8:55 pm
Location: United Kingdom
Organisation: Andrews Decorating
Interests: Reading, woodwork.

Hello!

Post by Mafell »

Really enjoyed reading the posts so thought I'd sign up and say hello.
I have unhealthy obsession with acquiring new tools, machinery and hobbies.
I am planning to have a go at making a mirror or two. I have acquired a Orteguil underpinner which I don't really have a clue about but I'm looking forward to finding out.
I have run out some mouldings on the router table, I don't have a guillotine so my mitres will be a bit rough on the chop saw, so I guess I will put a paint effect on the frames to disguise the joints a bit. May revert to using a chop service if initial results are unsatisfactory!

Laurie :D
User avatar
IFGL
Posts: 3087
Joined: Sun 06 May, 2012 5:27 pm
Location: Sheffield UK
Organisation: Inframe Gallery Ltd
Interests: Films ,music and art, my wife and kids are pretty cool too.
Location: Sheffield
Contact:

Re: Hello!

Post by IFGL »

Lol welcome and good luck with the chop service :D
User avatar
prospero
Posts: 11492
Joined: Tue 05 Jun, 2007 4:16 pm
Location: Lincolnshire

Re: Hello!

Post by prospero »

Welcome Mafell. :D

It's more good luck than judgement with a chop saw. The problem is that most don't have a fine adjustment on the pre-set stops. And slight inaccuracy accumulates on the final join. Some people use a sander to true up the angles, but this is a lot of faff and can make opposing rails a different length, which is just as bad as iffy angles. And a sander is not a cheap item. Better to have two saws for the left and right angles. This way you don't have to swing the heads and you could tweak it to a perfect cut. It would mean bolting them down to a bench though.

Good luck anyway. :yes:
Watch Out. There's A Humphrey About
A3DFramer
Posts: 200
Joined: Fri 18 May, 2012 6:51 pm
Location: Shropshire
Organisation: Collectors Cases
Interests: Virtual 3D Model making, Digital Graphics.
Location: Shropshire

Re: Hello!

Post by A3DFramer »

Best of luck with your venture. Many framers, perhaps most, start off with a mitre guillotine, but the old framers used to saw the angle cuts and shoot the joints with a plane, using a shooting board. It might be worth your while thinking of knocking up a shooting board as it only needs a few of strokes with a good plane to true up an angle give you a true joint.

If you 'google' shooting boards it will lead to many interesting demos on youtube. A lot other decor products to be made including pictures.
Mafell
Posts: 2
Joined: Sat 26 Jan, 2013 8:55 pm
Location: United Kingdom
Organisation: Andrews Decorating
Interests: Reading, woodwork.

Re: Hello!

Post by Mafell »

Thank you for the warm welcome and advice!

I will definitely have a go at making a shooting board!
User avatar
David McCormack
Posts: 1442
Joined: Tue 02 Aug, 2011 10:14 am
Location: South Lakes
Organisation: Framing
Interests: Cycling, walking, darkroom photography and laughing a lot!
Location: Cumbria
Contact:

Re: Hello!

Post by David McCormack »

How does that Monty Python song go....?
"You know, there's a right and wrong way to do everything!"
Oliver Hardy.
https://www.instagram.com/davidaustinmccormack/
Post Reply