Mountboard moulding
-
NTG999
- Posts: 157
- Joined: Wed 30 Nov, 2022 5:43 pm
- Location: Yorkshire
- Organisation: Avenues Picture Framing
- Interests: Classic cars
Mountboard moulding
A customer asked for a frame similar to attached photo, black frame with a deep rebate, there is a smaller moulding to edge the mountboard and step the picture back; it looks like the smaller moulding has a step for the mountboard (but I could be wrong), does anyone know if this style of moulding can be purchased anywhere?
You do not have the required permissions to view the files attached to this post.
-
YPF
- Posts: 463
- Joined: Mon 07 Sep, 2009 11:25 am
- Location: Worcester
- Organisation: Previously Your Picture Framer
- Interests: Now retired and about to move to Wiltshire to hone my woodturning skills and do some dog walking.
- Location: Worcester
Re: Mountboard moulding
Looks like a slip fitted to a mount with a reverse cut bevel. You should be able to get them from most suppliers - if you can’t find a black one get a plain wood and paint it
Steve
Chief Coffee Drinker
Chief Coffee Drinker
-
prospero
- Posts: 11698
- Joined: Tue 05 Jun, 2007 4:16 pm
- Location: Lincolnshire
Re: Mountboard moulding
That's what I would term a 'fillet'. 
Many suppliers make complimentary fillets that match a moulding (as appears to be the case there).
LJ/Arcadia did a lot but not sure what they do atm as I hardly never buy finished moulding.
You can always paint a plain wood one as YPF says.
A black one wouldn't be difficult.
Rose&Hollis do a few plain profiles.
Many suppliers make complimentary fillets that match a moulding (as appears to be the case there).
LJ/Arcadia did a lot but not sure what they do atm as I hardly never buy finished moulding.
You can always paint a plain wood one as YPF says.
A black one wouldn't be difficult. Rose&Hollis do a few plain profiles.
Watch Out. There's A Humphrey About
-
Justintime
- Posts: 2536
- Joined: Sat 26 Sep, 2015 8:48 am
- Location: West Wales
- Organisation: George The Framer LLP
- Interests: Gardening, design, electronic music, good food and beverages.
- Contact:
Re: Mountboard moulding
Yes, the fillet has a step for the reverse bevelled mountboard to butt up against. you will need to pinwheel some 1400 board underneath the mountboard to make it sit level.
Justin George GCF(APF)