Hi All
I’ve come back to using my Underpinner after a while - it starting working fine and then wasn’t punching staples all the way in - pressure at just over 6 bar. Now it has stopped working all together - top press doesn’t clamp down and hammer doesn’t seem to be moving. Air pressure is constant at over 6 Bar, lubricated the block and it isn’t blocked. I assume the top press arm should clamp down as the wedge is driven from underneath - neither engage!
I haven’t used this machine a great deal and not familiar with it enough to resolve my issue.
Any advice would be greatly appreciated.
Thanks in advance.
James
Cassese cs299 Mxl problem
-
james1967
- Posts: 13
- Joined: Tue 27 Oct, 2015 6:11 pm
- Location: Kent
- Organisation: James Saligari Photography
- Interests: Photography and Framing
-
Justintime
- Posts: 2345
- Joined: Sat 26 Sep, 2015 8:48 am
- Location: West Wales
- Organisation: George The Framer LLP
- Interests: Gardening, design, electronic music, good food and beverages.
- Contact:
Re: Cassese cs299 Mxl problem
Give Mark a call at Underpinner-spares.co.uk I'm sure he'll be able to diagnose the problem and supply you with the parts.
Justin George GCF(APF)
Insta: georgetheframer
Insta: georgetheframer
-
james1967
- Posts: 13
- Joined: Tue 27 Oct, 2015 6:11 pm
- Location: Kent
- Organisation: James Saligari Photography
- Interests: Photography and Framing
Re: Cassese cs299 Mxl problem
Will do.
Thanks
Thanks