Keencut Ultimate Gold - Squaring Issue

Get help and framing advice from the framing community
Post Reply
Tuffgirl
Posts: 3
Joined: Thu 26 Oct, 2023 9:54 pm
Location: Edinburgh
Organisation: Alina’s Precious Petals
Interests: Flower preservation and crafting.
Now learning framing

Keencut Ultimate Gold - Squaring Issue

Post by Tuffgirl »

Keencut Ultimat Gold – squaring issues with larger mountboards?

Hi everyone,

Just wondering if anyone else using a Keencut Ultimat Gold has experienced problems getting larger mountboards perfectly square?

I’ve noticed that when I’m cutting smaller boards, around 40 × 40 cm, everything seems accurate. All four sides measure correctly and the diagonals match.

However, when working with larger boards, around 75 × 52 cm, I’m sometimes getting discrepancies between opposite sides, despite taking care to square the board.

For example, on my latest board I ended up with:

* Top: 74.5 cm
* Bottom: 75 cm
* Left: 51.5 cm
* Right: 51.7 cm

That’s a 5 mm difference between the top and bottom, which is quite significant.

I’m using the bottom squaring arm as my reference and making sure the board is positioned against it before cutting.

I vaguely remember a former colleague mentioning that he’d occasionally experienced something similar with larger boards on the same machine.

Has anyone else come across this? I’m wondering whether it’s an issue with supporting and positioning larger boards, a slight alignment problem that becomes more noticeable over longer cuts, or something else entirely.

I’d be interested to hear your experiences and whether you’ve found a reliable way around it.

Thanks in advance!
User avatar
pramsay13
Posts: 1520
Joined: Tue 27 Sep, 2011 11:46 am
Location: Stonehouse, Lanarkshire
Organisation: Picture Framer (ML)
Interests: picture framing (no, really!) sport, music
Contact:

Re: Keencut Ultimate Gold - Squaring Issue

Post by pramsay13 »

I'm sure this has been discussed before on here at some point.
The squaring arm on my mountcutter flexes quite a bit which meant I was getting out of square cuts on large boards.
I imagine it is a wear issue as I have had the machine over 15 years and it was second hand when I got it, not sure how long the person had it before me.
I now use the measurement on the squaring arm, and then just measure the top bit with a ruler to make sure it's the same. It's a bit of a faff, but definitely better than cutting out of square.
Post Reply