Page 1 of 1
Fully serviced Morso blades
Posted: Fri 21 Jun, 2013 7:31 pm
by breery
Just replaced my Moros blades with a set that came back from Lion that they said were fully serviced but they are not exactly the same width. One is about 1 to 2mm narrower. Will this effect the cut (I have only cut narrow mouldings so far). Has anybody had this problem before and if so did Lion do anything about it. I Emailed them two days ago but have heard nothinh back so far.
Re: Fully serviced Morso blades
Posted: Sat 22 Jun, 2013 10:30 am
by prospero
If they can still be lined up at the front edge then you should have no problem. If not I would think the wider one needs to be ground to match the other. Otherwise the cut might go wonky or worse the cutter block channel might wear faster.
Re: Fully serviced Morso blades
Posted: Sat 22 Jun, 2013 6:22 pm
by breery
Thanks prospero, They line up fine at the front just that one side of the V is very slightly shorter.