Taurus underpinner clamp mouldings

[timja]

Hi,

We have a couple of Taurus Underpinners where you can change the rubber/silicone clamp head depending on what moulding you are pinning so it is shaped to the moulding and clamps very well.

Does anyone know where I can source some new ones to fit a new moulding we are using now that Taurus are no more?

Thanks

[prospero]

You could make your own.

Had a google to see what the machine looked like and hit http://www.framersequipment.co.uk/tauru ... ipment.htm


It says "spares available on request" so may be worth giving them call.


Welcome to the UKFF btw.

[timja]

Thanks, I did the same earlier and have left them a message so hopefully they will get back to me later.

Not sure if I have the skills to make my own, but I used to know someone who worked in special effects for film industry who could probably make a mould and mix up some kind of silicone to cast in it... may prove to be quite expensive however!