The Framers Forum

I normally cut all my mounts by hand on the keencut but I have an order for 24 double mounts, (probably leading to another 48) and I think it would be a better use of my time to order this.
Can anyone suggest a supplier.

I use moonshine mounts when I need multi appertures or can't be bothered cutting a load. Always a very good service

I am sure any of us with a cmc would do it for you.

We can do it.

Is that a double mount as in two layers with a reveal or a single layer with two windows? Are they all the same?

I mean 2 layers with the bottom layer revealed below. I would call that a double mount, or 3 layers a triple mount.
A single layer with two windows I would call it a single mount with double aperture.

So would I.

You could try Merlin Mounts

You can build your own on our website, but for quantity it would be best to contact us for best prices.

Try www.glenbrookemounts.com
They use white core boards
Pay by Paypal

Job done

Does anybodyuse cream core boards these days???

Depends what type of cream core Arqadia's hayseed is cream but conservation standard.

Fair play Alistair, but that was not quite what I meant

Might as well throw my hat in too, we can cut them on our Wizard 9000

If somehow all the other people can't do it because they all fell ill or summat, we could help as an absolute last resort if you don't mind waiting until March.

Probably could have cut them on a manual mount cutter by now

Lol, you are right.

That thought occurred to me too.

What did you all do with your spare time before you discovered this forum

I used to go out molesting squirrels.