Morso fence question
Posted: Mon 04 Mar, 2019 10:08 am
Hello all
I am sure this is a really stupid question but here goes. If I set the fences like the manual says I get an inside gap on the last join.Therefore I need to move the left fence towards me to get 45 degree cuts. Does that mean I need to physically bend the moulding to make it slightly concave i.e corespond to the slighly concave fences?
Hope this makes sense.
Thanks
I am sure this is a really stupid question but here goes. If I set the fences like the manual says I get an inside gap on the last join.Therefore I need to move the left fence towards me to get 45 degree cuts. Does that mean I need to physically bend the moulding to make it slightly concave i.e corespond to the slighly concave fences?
Hope this makes sense.
Thanks