Trying to source the supplier of this moulding used for a box frame to put baby hand and feet castings into.
The molding depth is 54mm and the width is 10mm its bare wood with a rebate.
Any suggestions please.
Identifying a frame
-
FandLframes
- Posts: 15
- Joined: Mon 07 Sep, 2015 7:56 pm
- Location: England
- Organisation: F and L Frames
- Interests: We are in the process of buying a small framing business and we are looking for help and advice!
Identifying a frame
You do not have the required permissions to view the files attached to this post.
-
JFeig
- Posts: 1476
- Joined: Thu 23 Sep, 2004 8:31 pm
- Location: Detroit, Michigan USA
- Organisation: minoxy, LLC
- Interests: non-fiction knowledge
Re: Identifying a frame
Is there a rebate on the bottom as well as the top?
That appears to be a raw timber "extender". It can be made in any woodworking shop with the simplest of tools, a hand saw and a plane.
A table saw can cut basic wood to width needed as well as the rebate. The mitered ends can be cut with the same saw or a dedicated miter saw.
That appears to be a raw timber "extender". It can be made in any woodworking shop with the simplest of tools, a hand saw and a plane.
A table saw can cut basic wood to width needed as well as the rebate. The mitered ends can be cut with the same saw or a dedicated miter saw.
Jerome Feig CPF®
-
FandLframes
- Posts: 15
- Joined: Mon 07 Sep, 2015 7:56 pm
- Location: England
- Organisation: F and L Frames
- Interests: We are in the process of buying a small framing business and we are looking for help and advice!
Re: Identifying a frame
No only rebate on one side. we do make similar versions but wondered if there was an option to buy a ready made length of these to create boxes for newborn casts etc
-
prospero
- Posts: 11698
- Joined: Tue 05 Jun, 2007 4:16 pm
- Location: Lincolnshire
Re: Identifying a frame
Have a word with these guys....
http://www.norfolkmouldings.co.uk/
I have found them are very good and min order only 100ft. Quick turn around.
The profile is simple and won't need special knives to be made.
http://www.norfolkmouldings.co.uk/
I have found them are very good and min order only 100ft. Quick turn around.
The profile is simple and won't need special knives to be made.
Watch Out. There's A Humphrey About
-
JKX
- Posts: 830
- Joined: Sun 08 Jan, 2023 10:25 pm
- Location: United Kingdom
- Organisation: Retired
- Interests: Calligraphy, gardening, framing rehabilitation
Re: Identifying a frame
It could be that the width is 54mm and the depth is 10mm - but it’s mitred on its side.
The first P.F.G. (and still one of only two)
outside of North America.
outside of North America.