Page 1 of 1
Cutter
Posted: Fri 28 Aug, 2009 7:34 pm
by Keith
Hi.
I'm looking to buy a cutter and came across the ONYX 90 MATERIALS CUTTER , just wonderd if anyone has one and if so how it performs.
Thanks Keith
Re: Cutter
Posted: Sat 29 Aug, 2009 7:24 pm
by Roboframer
Hello Keith & welcome to the forum,
Last time this cutter was discussed no-one on the forum had one - well, if they did they didn't say so.
Here's the link to that thread anyway - some observations good and bad that might help you.
http://theframersforum.com/viewtopic.ph ... 47&p=30235
Re: Cutter
Posted: Sat 29 Aug, 2009 11:26 pm
by Keith
Hi Roboframer.
Thanks for replying with the link, I think it best to try one first as the reviews were not conclusive, would like an Excaliber but haven't got the headroom.
Thanks Keith
Re: Cutter
Posted: Sun 30 Aug, 2009 12:06 am
by Roboframer
Roboframer wrote:Hello Keith & welcome to the forum,
No idea why I said that - must, for some reason, have thought this was your first post - you've been around here longer than I have!