The Framers Forum

I have have an Ademco 1822 hard bed press for sale which I no longer require. Will accept any reasonable offer.

We are based just outside Fort William, Highlands so the buyer would have to collect in person. Please note that this is a heavy item and would require two strong people to carry it.

Hi there,
Can you give me some details about your press (assuming it's still for sale!)? What is the its size i.e. the plate size as well as its rough overall dimensions? I have used the 2226 which is pretty huge and am looking for something slightly smaller.

Thanks.

It is approximately 96” long, 18” wide and 23” tall.

Ademco Heat Press
Drymounting / Laminating
Plate 22"x 18"
Thermostatically controlled
Electrical mains supply 240 volts

96" long?

I think the 18/22 has the same chassis size as the 22/26. It's just the platen that is bigger.

Sounds like a job for a fork lift

Oops, I meant 96cm long and about 45cm wide.