Page 1 of 1
Suedette Board
Posted: Tue 14 Jun, 2011 11:04 am
by misterdiy
I have ust had a job in that needs a suedette mount with a bevel aperture. Cutting it is fine on my CMC but it leaves tramlines from the cutter roller around the cut-out. As I can't cut the bevel from the back, is there any way that the tramlines can be removed? Any help gratefully recieved
Re: Suedette Board
Posted: Tue 14 Jun, 2011 12:04 pm
by markw
Why cant you cut from the back?
Re: Suedette Board
Posted: Tue 14 Jun, 2011 12:23 pm
by Tudor Rose
We always cut suedette mountboard from the back - that is the only surefire way to avoid tramlines.
Re: Suedette Board
Posted: Tue 14 Jun, 2011 12:53 pm
by Steve N
Re: Suedette Board
Posted: Tue 14 Jun, 2011 6:37 pm
by misterdiy
The reason we couldn't cut from the back was the spring in the board. We have a vacuum bed and it was springing up - even with masking tape to hold it down. Hence top cut.
Thanks Steve N, a very useful thread.
Steve