The Framers Forum

Hi Guys,

I am now in a position to purchase a new underpinner, and was would like to know what people recommend.
Thanks in advance.

Kathy

Kathy
You might get more realistic responses if you stated the volume and type of moulding you are using. Also what your budget is.

Apologies, should have given more info. My budget is approximately £1000.00. Volumes are unkown, as this is business is still in its early stages.

In addition to the standard picutres/photos, I hope to include sports jerseys, fabric and 3D items. I expect the lengths to be over 55 cm in length, using moulding widths of up to 5.5 - 6 cm and rebate depths of 15mm or more.


Regards,
Kathy

Cassese CS88 seems to be a popular and reliable starter machine within your budget. I would not bother with the pnuematic version as the mechanicals are the same except for air powered hammer and clamp.

Lion no longer sell Cassese but they do have an Inmes pnuematic at under £1000 (list £999). Not heard any reports on them but perhaps other forum members might be able to tell you.

Framers Equipment in Northampton is worth checking out and they do have some secondhand machines form time to time with guarentee and service back up.

Check out the Wessex pictures web site as well for their 2nd hand machines.

Agree Cassesse is a good starting point.

As I'm someone who recently did the same thing (bought a second hand manual Cassese), you should also be aware that you'll NEED either extension arms or an additional means of supporting longer mouldings. I obtained a large supply of knackered moulding through trying to balance longer lengths on all sorts of shelves, boxes and the wife before building a suitable bench extension!

If you have a decent sized workbench and can find a table-top model, you can sink it in to one corner to make the whole bench your frame support.