The Framers Forum

I earnt no money today but got a lot of pleasure out of clearing out all the "furry" mountboard from under my bench, hoovering it all out and taking a boot load of off-cuts to the local tip. I then fitted the LION Guillotine I bought second hand on the Forum before Christmas ... it was very easy to fit surprisingly and you can't beat the cut of a Guillotine over the Excalibur for MDF board and mountboard ( IMHO ).

I'll have to do some "proper" work tomorrow but it was good to clear the decks and start afresh, I even did a stock take of my mountboard

For me it was 3 months shredding over the bank holiday weekend...

Know what you mean. I've been painting concrete walls, putting up shelves and new worktops in the "dirty" part of workshop (sawing, chopping and sanding).

Question now is - should I also paint the concrete floor, or is that going too far?