Page 1 of 1
Identifying a frame
Posted: Tue 07 Nov, 2023 12:41 pm
by FandLframes
Trying to source the supplier of this moulding used for a box frame to put baby hand and feet castings into.
The molding depth is 54mm and the width is 10mm its bare wood with a rebate.
Any suggestions please.
Re: Identifying a frame
Posted: Tue 07 Nov, 2023 1:19 pm
by JFeig
Is there a rebate on the bottom as well as the top?
That appears to be a raw timber "extender". It can be made in any woodworking shop with the simplest of tools, a hand saw and a plane.
A table saw can cut basic wood to width needed as well as the rebate. The mitered ends can be cut with the same saw or a dedicated miter saw.
Re: Identifying a frame
Posted: Tue 07 Nov, 2023 11:33 pm
by FandLframes
No only rebate on one side. we do make similar versions but wondered if there was an option to buy a ready made length of these to create boxes for newborn casts etc
Re: Identifying a frame
Posted: Wed 08 Nov, 2023 1:42 am
by prospero
Have a word with these guys....
http://www.norfolkmouldings.co.uk/
I have found them are very good and min order only 100ft. Quick turn around.
The profile is simple and won't need special knives to be made.
Re: Identifying a frame
Posted: Wed 08 Nov, 2023 9:27 am
by JKX
It could be that the width is 54mm and the depth is 10mm - but it’s mitred on its side.